Operating instructions

Recalculation
Factory Settings
Print application parameters (automatic
output of application parameters):
all values
Printout configuration:
Line format:
for other
apps/GLP (22 characters)
Soft Key Functions
Comp.xx Store component
Add.xx Store component in
additive weighing mode
Div. Store divisor before
or during component
weighing
Recalc Start correction procedure
for recalculation
UAdd./ Toggle display between
UComp. component weight and
total weight (additive
mode)
Comp. Store numeric input for
recalculation
Minus Set value given for the
formulation
Plus Set value given for the
formulation
Preparation
§ Turn on the scale: press e
> Sartorius logo is displayed
● Select the Recalculation application in the Setup menu: press H
● Select
Calculation: press the Q or q soft key, repeatedly, if neccessary
● Confirm
Calculation: press the O soft key
● Select
Recalculation: press the Q or q soft key, repeatedly, if neccessary
● Confirm
Recalculation: press the o soft key
● Save settings and exit the Setup menu: press the oo soft key
Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during alphanumeric input), and
– printing,
you can also access the following functions
from this application:
Calibration/Adjustment
● Press the
isoTST soft key
> See “Calibration/Adjustment”
for further instructions
Toggling to the Next Application
● Press D
> See the section on the corresponding
application program for further
instructions
Setup (setting parameters)
● Press H
> See “Configuration” for
further instructions
Turning Off the Scale
● Press e
> The scale shuts off
66