Operating instructions

Totalizing
L
Preparation
● Turn on the scale: press e
> Sartorius logo is displayed
● Select the Totalizing application program in the Setup menu: press H
● Select the
Application parameters: press the q soft key 2 +,
then the O soft key
● Select
Totalizing: press the Q or the q soft key
● Select
Totalizing: press the O soft key
Totalizing Automatic
ο Off
storage On, first value at stability
On, last value at stability
On, value bet. 70 – 130% at stabil.
Minimum load for None
automatic storage: 10 digits
ο 20 digits
50 digits
100 digits
200 digits
500 digits
1000 digits
Source of data for
ο Application 1
auto storage Application 2
Evaluated values
ο Net
Calculated
Net + calculated
Evaluation mode,
ο Intermediate evaluation, print
MR function Final evaluation, print
Intermediate evaluation, display+print
Final evaluation, display+print
M+/M– function,
ο Off
then tare On
Printout of individual No
components
ο Yes
ο = factory setting
see also the “Application Parameters (Overview)” in the chapter entitled “Configuration”
● Save settings and exit the Setup menu: press the
oo soft key
Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during alphanumeric input),
– printing,
you can also access the following
functions from this application:
Calibration/Adjustment
● Press the
isoTST soft key
> See “Calibration/Adjustment”
for further instructions
Toggling to Another Application
● Press D
> See the section on the corresponding
application program for further
instructions
Setup (Setting Parameters)
● Press H
> See “Configuration” for further
instructions
Turning Off the Scale
● Press e
> The scale shuts off
80