User's Manual

Acceptable temperatures.
The product is designed to be used between 0 degrees and 40
degrees C (32 degrees and 104 degrees F).
It can be stored between -20 degrees and 50 degrees
C (-4 degrees and 122 degrees F). Low or high temperature conditions might lead the product
to temporarily stop working, or working properly. Allow unit to return to room temperature after
storage at high or low temperatures before operation.
FCC Statement.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause
undesired operation. NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the
equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna,
Increase the separation between the equipment and receiver, Connect the equipment into an
outlet on a circuit dierent from that to which the receiver is connected and Consult the dealer
or an experienced radio/TV technician for help.
I
mportant.
Any modications to the unit, unless expressly approved by the party responsible
for compliance, could void the user’s authority to operate the equipment. The product has
demonstrated EMC compliance under conditions that included the use of compliant peripheral
devices and shielded cables between system components. It is important that you use the
compliant peripheral devices and shielded cables between system components to reduce the
possibility of causing interference to radios, televisions and other electronics devices.
Canadian Compliance Statement.
Complies with the Canadian ICES-003 Class B specications.
Cet appareil numerique de la lass B est conforme a la norme NMB-003 du Canada. This device
complies with RSS 210 of Industry Canada. This Class B device meets all the requirements of
the Canadian
interference-causing equipment regulations. Cet appareil numerique de la Classe
B respecte toutes les exigences du Reglement sur le materiel brouilleur du Canada. This device
complies with Industry Canada license-exempt RSS-210 standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including
interference that may cause undesired operation of the
device.
Cet appareil est conforme aux normes CNR exemptes de licence d’Inustrie Canada. Le
fonctionnement est soumis aux deus conditions suivantes: (1) cet appareil ne doit pa provoquer
d’interferences et (2) cet appareil doit accepter toute interference, y compris celles susceptibles
de provoquer un fonctionnement non souhaite de l’appareil.
EU Compliance Statement. Swivl hereby declares that this wireless device is in compliance with
the essential requirements and other relevant provisions of the R&TTE Directive.
TM and © 2015 Swivl. All rights reserved. Swivl, the Swivl logo and all other company, product and
service names or slogans are trademarks of Swivl. Patent pending.
iPad, iPhone, and iPod touch are trademarks of Apple, Inc., registered in the U.S. and other coun-
tries.
Swivl | 1354 El Camino Real | San Carlos CA 94070 | (888) 837 6209
Printed in China. MC-00319.
Information Guide
2/2