User manual

User Manual INTEGRA 14
installer so that pressing the key [1] will be required). The [
*
] key enables exiting the function
without saving the changes (which can result in quitting the user menu).
Selection from the single-choice list
Shown in the upper line of display is description of the function, and in the lower one – the
currently selected item. You can scroll through the list of items, using the direction keys: T
(down) and S (up). The X and W keys are not used.
Selection from the multiple-choice list in the text mode
Shown in the upper line of display is description of the function, and in the lower one - an
item which can be selected. You can scroll through the list of items, using the direction keys:
T (down) and S (up). An additional symbol is displayed in the upper right corner:
– item not selected (e.g. partition, zone, output, etc.);
– item selected (e.g. partition, zone, output, etc.).
Press any numeric key to change the currently displayed symbol to another one.
Selection from the multiple-choice list in the graphic mode
The graphic mode is available in some functions which enable multiple selection (e.g.
selection of the partitions which are to be armed; selection of the zones which are to be
bypassed, etc.). The keypad will enter the graphic mode on pressing the X or W key. The
and symbols are used to present on the display the status of items available within the
function – these can be e.g. partitions, zones, outputs, etc. ( – item not selected; – item
selected). The numbers around the display are used for numbering the items. The X key will
move the cursor to the right, and the W key – to the left . Pressing any numeric key will
change the currently displayed symbol to another one. The blank spaces (where no symbol is
displayed) are the unavailable items (e.g. partitions which cannot be armed or disarmed;
zones which cannot be bypassed, etc.) over which you cannot hover the cursor.
The display makes it possible to simultaneously present up to 32 items in the graphic mode,
while the number of items in some functions can be higher (e.g. there are 128 zones in the
system). If this is the case, go to the last available item and press the X key to display the
next group of 32 items. If you press the W key when the cursor is on the first available item,
the previous group will be displayed. The number of currently displayed group is presented
by means of LEDs designated [GROUP] (see: description of the LEDs, p. 11). To calculate
the number of items in the subsequent groups, add the number 32 (second group), 64 (third
group) or 96 (fourth group), respectively, to the number placed on the glass.
Pressing the key [0], [1] or [2] in the graphic mode will result in:
[0][0][0] - canceling the selection of any item (the symbol will be displayed in all
available positions);
[1][1][1] - selecting all available items (the symbol will be displayed in all available
positions);
[2][2][2] - reversing the selections made (the symbol will replace the symbol, and the
symbol will replace the symbol in all positions).
On pressing the T or S key, the keypad will return to the text mode.
Entering decimal values
Press suitable keys to enter digits. Use the X key to move the cursor to the right, and the W
key – to move the cursor to the left. Use the S key to delete the character before the cursor.
Entering names
Press the particular keys until the required character appears. The characters available in the
keypad are shown in Table 1. Hold down the key to display the digit assigned to the key.