User manual

INTEGRA SATEL

SATEL offers the following partition keypads for INTEGRA control panels:

− INT-S-GR/INT-S-BL

− INT-SK-GR

These keypads differ by size and shape. The keypads are available with green or blue

backlighting of the keys. Designation of the models with green display ends with "GR" letters,

and that of the models with blue display – with "BL" letters. The backlighting may be

permanent or time-controlled (switched on automatically).

Fig. 5. INT-SK-GR partition keypad.

The partition keypads are provided with LED indicators:

ALARM (red) – permanent lighting of the LED means alarm. After the alarm time

expires, blinking of the LED indicates the alarm memory. The LED goes off after the

alarm is cleared (see: ALARMS).

Note: The LED may not signal alarms in the armed mode if the installer has enabled the

option DO NOT SHOW ALARM IF ARMED, as required by the CLC/TS 50131-3 standard.

- ARMED (green) – steady light indicates that the partition the keypad is assigned to, is

armed. Blinking indicates that exit delay countdown is underway.

TROUBLE (yellow) – blinking indicates occurrence of a technical problem. The signaling

refers to the troubles from the entire alarm system, not only from the keypad controlled

partition. Check the LCD keypad for the type of trouble. The LED is off when the

partition controlled by the keypad is armed. Disarming will restore the trouble

signaling. The LED is blinking until troubles are viewed in the LCD keypad and the

trouble memory is reset (option TROUBLE MEMORY UNTIL REVIEW enabled) or until the

trouble cause stops (option TROUBLE MEMORY UNTIL REVIEW disabled) PROG.