User manual

User Manual INTEGRA 20
4. change of the code has been blocked because another user "hit" this code at an attempt
to change his own code. If the function of prompting about the necessity to change the
code is activated, each use of such a "hit" code will be signaled with three double beeps.
In such a case the change of the code will be only possible by means of the LCD keypad
– and confirmation of the code change will be required (see: description of the CHANGE
OWN CODE
function) by the object master user. This feature makes impossible "capture" of
the code by a user who accidentally "hit" the code.
Note: With a large number of users it is advisable to use longer, at least 5-digit codes, to
reduce the chance of "hitting" another user's code. The CLC/TS 50131-3 standard
requires that 6-digit codes be used.
6.3 MULTIFUNCTIONAL KEYPAD WITH PROXIMITY CARD READER
The INT-SCR-BL multifunctional keypad with proximity
card reader can work as:
• partition keypad (see section: PARTITION KEYPADS);
• partition keypad with proximity card reader
- having the functionality of partition keypad,
enhanced by an option to identify users, based
on the proximity card;
• entry keypad – entering the access code
(password) or reading in the card will unlock the
time delay for interior delayed zones.
The keypad design enables it to be installed outdoors.
Additionally, the device is fitted with a bell button.
The keypad has two LEDs which are intended for
signaling:
- ALARM (red color),
- ARMED (green color),
- TROUBLE (yellow color).
Information conveyed with the LEDs depends on the
keypad operating mode. Blinking of all the LEDs in
turn (from left to right) indicates that there is no
communication with the control panel. Such a situation
may take place when the STARTER program is
running in the control panel, or the connecting cable
between keypad and control panel is defective.
6.3.1 Operation in partition keypad mode
(INT-S/SK)
The proximity card reader is not supported in this
mode. Information conveyed by means of the LEDs,
audible signaling and functionality have been
described in section PARTITION KEYPADS.
Note: In order to trigger the fire alarm, press and hold
down the
key for approx. 3 seconds, and to
trigger the PANIC alarm, press and hold down
the
key for approx. 3 seconds.
Fig. 6. Multifunctional keypad
INT-SCR-BL.