User manual

User Manual INTEGRA 28
− DURESS – used in an emergency situation, when the user has been forced to enter the
code. Using the code will trigger a silent alarm. By default, the DURESS prefix consists of
a suitable number of digits 4 (e.g. if the determined prefix length is 3, the default prefix is
444).
For security reasons, it is useful to periodically change the prefixes. The master user of the
object is authorized to change the prefixes and define the change R
ECALL TIME (see function
ÆCHANGE PREFIX).
Notes!
• Changing the length of prefixes is possible only from the real keypads.
• Changing the length of prefixes by the installer restores their default values.
6.8 PROXIMITY CARDS/DALLAS CHIPS
The users of INTEGRA security alarm system (excluding the service) can be assigned
a proximity card and a DALLAS chip. The maser users can only be assigned a card / chip by
the service. The other users can be assigned a card / chip by the serviceman (if he has been
authorized to do so by the master user), master user or a user with the EDIT USER authority
level.
Note: The same card/chip cannot be assigned to two users.
6.8.1 Adding proximity card / DALLAS chip by means of LCD keypad
1. Start the NEW PROX. CARD / NEW DALLAS function.
2. Specify the reader (device with a reader) where the card/chip is to be read in, or select
entering the card/chip number manually.
3. Depending on the indicated method of card addition:
− read in the card/chip twice, following the prompts on the keypad display, and, after the
"Card read"/“DALLAS read" message is displayed, press [#];
− enter the card/chip number.
The card/chip will only be actually added after completion of the user adding /
editing procedure, i.e. after exiting the function by means of the [
*
] key and
saving the changes by means of the [1] key.
6.8.2 Adding proximity card / DALLAS chip by means of DLOADX program
1. Open the U
SERS window.
2. Click with your mouse pointer on the selected user.
3. Click with your mouse pointer on the C
ARD / DALLAS button. The card/chip adding window
will open.
4. Select the reader (device with a reader) to be used for reading in the card/chip.
5. Click with your mouse pointer on the ADD CARD / ADD DALLAS button.
6. According to the commands displayed in the window, read in the card/chip twice and,
after the C
ARD READ / DALLAS READ message appears, close the window.
7. Save the data to the control panel. The card/chip is now added.
Note: You can also add the card/chip by entering its number in the C
ARD / DALLAS field,
USERS window, and saving the data to the control panel.
6.8.3 Adding proximity card / DALLAS chip by means of GUARDX program
1. Open the USERS window.
2. Click with your mouse pointer on the selected user.