User manual

User Manual INTEGRA 30
zone will be violated as long as the keyfob button is depressed) and a corresponding reaction
of the control panel. A button/combination of buttons can control one zone in the system.
Zones are assigned to buttons/combinations of buttons individually for each user.
On pressing any keyfob button (which does not have to control a system zone), information
on the status of three selected system outputs will be presented for a few seconds on the
keyfob LEDs. Thus you can get confirmation of the function execution or information on the
current status of the system. The outputs on which the status is presented by means of the
keyfob LEDs do not have to physically exist. Up to 8 system outputs can be used for
providing information to the keyfob users.
Pressing any button/combination of buttons in the keyfob can generate an event informing
that a keyfob has been used. Generating such events can be enabled or disabled, so as to
reduce the number of events in the system.
Note: Dependencies between the keyfob buttons and the security system zones, as defined
for the user, will not be reset after the keyfob is removed (the only exception being the
REMOVE ABAX KEYFOB function, available in the service menu of LCD keypad). After
a new keyfob is added to the user, the buttons will control exactly the same zones, as
the buttons of the removed keyfob.
You can add the keyfob by entering its serial number manually or reading the serial number
during transmission which is sent after the button is pressed.
Note: The same keyfob cannot be assigned to two users.
The keyfob data are stored by the ABAX system (i.e. the wireless system of the mainboard of
INTEGRA 128-WRL control panel or the ACU-100 controller with firmware version 2.0 or
later). Connecting the ACU-100 controller with keyfob data to the INTEGRA 24,
INTEGRA 32, INTEGRA 64 or INTEGRA 128 control panel will result in keyfobs being
automatically assigned to the users of that control panel. This only applies to the users who
have already been created.
In case of LCD keypad, the keyfob will be added to / removed from the system,
the zones will only be assigned to the buttons, the outputs to the LEDs, etc.
after completion of the function of adding/editing administrator or user, i.e. after
exiting the function with the [
*
] key and saving the introduced changes by
pressing the key [1].
In case of DloadX program, the keyfob will be added to / removed from the
system, the zones will only be assigned to the buttons, the outputs to the LEDs,
etc. after the data are saved into the ABAX system (INTEGRA 128-WRL control
panel mainboard and ACU-100 controllers). In case of the INTEGRA 128-WRL
control panel, click your mouse on the button. In case of the other control
panels, click on the Write button in the ABAX Keyfobs window.
6.9.1 Adding keyfob by means of LCD keypad
Adding of the ke fobs is possible owing to the NEW ABAX KEYFOB function ([service code][
*
]
ÆMASTERS ÆNEW MASTER/EDIT MASTER ÆNEW ABAX KEYFOB or [code][
*
] ÆUSERS ÆNEW
USER
/EDIT USER ÆNEW ABAX KEYFOB).
Entering the serial number manually
1. Select ENTER MANUALLY from the list.
2. Enter the keyfob number and press the [#] key.