User manual

User Manual INTEGRA 34
6.9.10 Configuring event generation rules by means of DLOADX program
Enabling/disabling generation of events for particular keyfob buttons is possible by using the
ABAX KEYFOBS window, after the keyfob data have been read (see section ADDING KEYFOB BY
MEANS OF
DLOADX PROGRAM).
1. Click at the selected user in the column corresponding to the button/combination of
buttons for which you want to enable/disable the generation of events.
2. Using the SPACE button, enable/disable the event generation feature. The event
generation for the given button is disabled, if the
8
symbol is shown next to the number of
zone controlled by the button (lack of the symbol means that the event generation is
enabled). Any modification of the settings will change the background color in part of the
field next to the zone number into pink. After the data are saved into the ABAX system,
which completes the procedure, the field background will change its color to white.
6.10 SYSTEM ARMED MODE
The control panel performs its facility protection functions primarily when the system is
armed. When in the armed mode, any change of the zone state to another one, different from
that defined for the normal state (e.g. as a result of motion being detected by the detector,
opening the reed switch contacts after opening the window or door, etc.), will trigger
a reaction programmed by the installer (e.g. activate sirens, report the event to monitoring
station, etc.).
The user can arm the system using one of the following ways:
• entering [CODE][#] in LCD keypad – all partitions or some selected partitions only can
be armed;
• entering [CODE][#] in partition keypad – the partition to which the keypad is assigned
can be armed;
• entering [CODE][
*
] in LCD keypad and choosing ARM function – selected partitions
can be armed; if any of the partitions controlled by the keypad is armed, this is the only
way to arm of the other partitions;
• entering [0][#] in LCD keypad – all installer programmed partitions will be armed;
• entering [0][#] in partition keypad – the partition to which the keypad is assigned will be
armed;
• presenting and holding the card in face of the reader until the selected LED in
INT-CR proximity card arm/disarm device comes on – the partitions assigned to the
given LED by the installer will be armed;
• holding card in the proximity of the reader for approximately 3 seconds – the
partition to which the reader is assigned will be armed;
• holding DALLAS chip in the reader for approximately 3 seconds – the partition to
which the reader is assigned will be armed.
Notes:
• The control panel will not arm the partition(s) in the following cases:
− at least one zone with active P
RIORITY option is violated in the selected partition;
− the options R
EQUIRED SYSTEM RESET AFTER VERIFIED ALARM, DO NOT ARM IF TAMPER, DO
NOT ARM IF BATTERY TROUBLE
, DO NOT ARM IF TROUBLE, DO NOT ARM IF OUTPUTS TROUBLE
and DO NOT ARM IF REPORTING TROUBLE are enabled and at least one of such situations
takes place.
In case of arming by means of the LCD keypad, a list of causes which prevent arming will
be displayed. Press the [
*
] key to cancel the arming. Press the [#] key to repeat the
attempt of arming (without having to select partitions or armed mode status). If the cause