User manual

User Manual INTEGRA 38
messages into SMS messages, thus allowing the use of this form of notifying also in the
other INTEGRA control panels.
The number of telephones to which the messaging is effected, and the number of available
voice messages or text messages, depends on the control panel size.
In case of notifying by a voice message, the control panel settings may require confirmation
(acknowledgement) that the message has been listened to. If there is no such confirmation,
the control panel can make further attempts to connect and play back the message.
The number of redials and the confirmation rules (code) are defined by the installer.
A telephone with DTMF tone dialing must be used for the confirmation.
If the entered code is wrong, the control panel will signal the fact with two long tones (beeps).
Correct code is confirmed by four short and one long beeps. If a single short beep is heard
every three seconds instead of the above mentioned signals, the code is correct but you
must wait, because there are several messages regarding different alarms.
If you make a mistake when entering the code, press any numeric key to supplement the
code to four digits (then the control panel will signal a wrong code), and then re-enter the
correct code.
Notes:
• The control panel analyzes telephone signals in order to recognize whether the call is
answered. Therefore, it may occur that you will hear the message after few seconds (up to
4 seconds) from picking the handset. This is not an error – the effect is a result of the
phone call-back signal. When you say "hallo..." to the handset, the message will be
reproduced immediately.
• Acknowledgement of message reception by the user can reset the function of messaging
to other users PROG.
• If no confirmation rules for having listened to the message are defined in the control panel
by the installer, the control panel will recognize reception of the message as confirmed,
when the receiver is lifted after two rings and any sound occurs.
6.13 ANSWERING PHONE CALLS
The users having a telephone code (not to be confused with the acknowledgement code for
receipt of a telephone message) can use the call answering and telephone control functions.
The call answering function allows to obtain information on the state of partitions (armed,
alarms) to which the given user has access. Owing to the telephone control function, the
users with a telephone code can control the REMOTE SWITCH outputs. The installer defines
which switches can be controlled by the given user. The call answering and telephone control
functions require that a telephone with DTMF tone dialing be used.
Note: Not all cellular telephones allow control in DTMF tone system.
How to use this function:
• Dial the telephone number (line) of the control panel. The method of dialing is defined by
the installer. The control panel may establish connection after a defined number of dialing
signals (rings). The dialing can be single or double. When double dialing is used, wait until
a defined number of “rings" is completed, put the handset off, and then dial the control
panel telephone number again. After the number is dialed the second time, the control
panel should answer immediately.
• After the connection is established, the control panel is ready to receive the user telephone
code – three short beeps (handshake).
• Enter the code from the telephone keypad (in tone system). The control panel will
acknowledge the correct code with a series consisting of four short and one long beeps.