User manual

INTEGRA SATEL 39
Two long beeps follow receipt of an incorrect code. If the entered code is invalid, the
control panel will signal it by two long beeps and will not be answering any calls for the
next 4 minutes.
• The control panel is in partition status information mode. It waits for user’s response for 15
seconds, generating one short beep every two seconds. You are expected to enter the
partition number from the telephone keypad (in two-digit format, e.g., 01; 05; 12; 25).
If there is no response within this time, the control panel will ring off.
• After the partition number is entered, the control panel generates the message. Three
short beeps inform that the partition is disarmed and four short and one long beeps mean
that the partition is armed.
• Alarm memory is the extra information given by the control panel. If an alarm occurred in
the partition, the control panel generates a series of double beeps – one lower and the
other higher – following the partition status information. If there was no alarm, the control
panel will generate a single short beep every two seconds.
• In order to proceed to the control of the remote switches status, press [2] and [#] on the
telephone keypad. After the control function is entered, a periodic signal in the form of two
short beeps can be heard in the receiver.
• Now the control panel waits for the (two-digit) switch number to be entered. Entering the
telephone number from the telephone keypad will switch the relay status to the opposite
one. Three short beeps mean that the relay is switched off and four short and one long
beeps - that the relay is switched on. Each time you enter the same number, the relay
status is changed to the opposite one.
• It is possible to move back to the partition status indication mode by pressing in turn the [1]
and [#] keys.
• Pressing in turn the [0] and [#] keys will exit the function and terminate the telephone
connection.
6.14 OTHER FUNCTIONS USING TELEPHONE LINE
If functions of the control panel telephone communicator are used in the alarm system, then
the facility public line should be directly connected to the control panel, and all telephone sets
should be installed after the control panel. Therefore, no signals are heard in telephones
connected after the control panel, when the panel is on the telephone line. This situation may
frequently occur in multi-partition systems, when monitoring is activated (a special reporting
system intended for sending information on the object status to a security agency, working
independently of the aforementioned user notification system). Moreover, the control panel
will disconnect telephone conversations to capture the telephone line in order to transmit an
information on a new event. It should be noted that such connections do not last very long
(from a few seconds to one minute, depending on the selected format of data transmission).
Another function, when the control panel occupies the telephone line, is programming by
telephone (“downloading"). The service may initialize this function by phone. During data
interchange with the service computer, the telephone line may be occupied for a long time.
Even if the programming is initialized by the user, the service may suspend communication
with the control panel to reduce the connection costs, and then resume it without involvement
of the user.
Notes:
• The downloading function will be automatically stopped, if 255 minutes have elapsed since
the last use of the DLOADX program, and the service access was blocked or expired in the
meantime.