User manual

User Manual INTEGRA 46
Arming mode
This function makes it possible to select a special mode of arming, which will allow the user
to stay in the facility. The following armed modes are available:
• Full (default)
• Full + bypasses
• Stay
• Stay, delay = 0 (off)
The special armed modes are discussed in section S
YSTEM ARMED MODE, page 35.
After selection of the arming mode, the control panel returns to the user function menu, thus
enabling the selected partitions to be armed.
Exiting the menu without arming ([
*
] key) will cancel the selection made with this function.
Cancel 1st code
This function makes it possible to cancel the decision to enter the first code for
arming/disarming the two-code operated partitions. After calling the function, the control
panel will display the list of partitions for which the given user has entered the first code, and
will start countdown of the code validity time. You should select the required partitions from
the list and press [#]. Validity of the first code for arming/disarming the selected partitions will
be cancelled.
Change own code
This function makes it possible to change the code of the user, who called this function.
For a better safety of the system, it is recommended to change user code periodically (there
is always a risk that an unauthorized person might have seen the code).
The control panel requests the user to change his code in the following cases:
• New user – the new user code is known to the person who has entered him in the system,
therefore it must be changed. Until the code is changed by the new user, the "Change
code" message will be displayed. A failure to comply with this request has no
consequences in terms of the assigned authority level and/or access to the partitions.
• Expiry of the validity time of the "Time renewable" code (see the U
SERS function).
• Hitting the user code – it may happen when entering a new code by any user that he
enters a code already used in the system. Such a "guessed" code will be rejected,
however its present user will be informed that it is necessary to change the code.
In the first two cases, the procedure of entering a new code is simple: having started the
function, enter the new code and confirm it by pressing the [#] key.
If the code has been guessed, the procedure is more complicated, as it requires confirmation
of the code change by the master user or the serviceman: having entered the new code,
confirmed by pressing [#], it is necessary to enter the master code or the service code
(in case the master user code has been guessed).
Note: Using the service code is possible after enabling the service access by the master
user.
It is possible for the service to activate the option which blocks creating easy-to-guess codes.
When this option is activated, the control panel does not allow to create such codes as e.g.
1111, 1234, 1122 etc. These codes will be rejected, and the control panel will wait for another
combination of digits.
Note: The control panel does not recognize the code which is identical to the old code as
a new one.