User manual

User Manual INTEGRA 52
Events
The function makes possible to scroll the list of events stored in the control panel memory.
The events are given in the sequence order of their occurrence. The S key permits going
back to the previous event, while the T key – to the next one. If none of these keys is
depressed for a few seconds, names related to the particular event will appear on the
display, shown alternately with the event description.
The event description contains data displayed in the following format:
date - DD:MM (day:month),
time - HH:mm (hour:minute),
identifier - xxxx (four characters – IDEN) which identifies the number of zone,
partition, module, user operating the system, special symbol,
event name - text in second display line.
Description of meaning of identifiers:
Ser. user – service code,
Mst[n] [n]=1–8 user – object master code,
u [n] [n]=1–240 ordinary user of the system,
k [n] [n]=0–15 keypad – module connected to the keypad bus or virtual keypad
accessible from the program GUARDX,
0–7 numbers of keypads in the system,
8–15 numbers of keypads accessible from the program GUARDX, defined
as follows: no. of keypad to which the user computer is connected
plus 8,
DLrs keypad connected to the main board RS port, accessible from the
program DLOADX,
DLtl keypad connected to telephone line at the main board, accessible
from the program DLOADX,
e [n] [n]=0–63 expander - module connected to the expander bus (0–31 bus 1, 32
63 bus 2),
p [n] [n]=1–32 partition,
z [n] [n]=1–128 zone,
T [n] [n]=1–64 timer,
Tpar partition timer,
MnPl control panel main board.
Some of event descriptions allow readout of two identifiers, for example: partition number and
zone number, keypad number and user number, etc. To read the second identifier, press the
W key. Press the key again to change the displayed identifier for the previous one. Press the
X key to display the names related to identifiers, and again to restore the event description
display. Using one of the W X keys stops the automatic changeover between displaying the
particular event description and the names related to the identifiers. Going over to a next
event (key S or T) will restore the mode of automatic changeover of the display contents.
Either viewing of all events or viewing of selected events is possible. Also, you may choose
partitions to be viewed. The selection is made for partitions controlled by the keypad and, at
the same time, accessible to the user, who called the function.
If the user wants to view selected events, he has to mark at least one event type (the
symbol must appear at the name of event type), otherwise the menu function V
IEW is not
accessible. Marking of a partition is not necessary. When the partitions are not marked, the
list of events from all partitions accessible for the user is displayed.