User manual

User Manual INTEGRA 58
The function can be started from LCD keypad, without entering of any code, by pressing
successively the [8] and [#] keys PROG.
Starting the function by the user will display a list of output groups. You can scroll the by
means of the S and T keys. After selecting one of the output groups and pressing the [#] or
X key, a list of controllable outputs will be displayed. Press the W key to return to the group
list.
Note: If the outputs are only assigned to one output group, starting the OUTPUTS CONTROL
function will not be followed by displaying the list of output groups in the keypad, but
immediately by the list of controllable outputs.
To quit the function, press the [
*
] key.
Controlling the MONO SWITCH type of output
The output status is indicated on the display in the following manner:
- output inactive (disabled),
- output active (enabled).
The output is controlled by using the X or [#] key. Press the X key to activate the output for
the time programmed in the control panel. Press the [#] key to define the output cutoff time
(irrespective of the time programmed in the control panel by the installer). Having defined the
output cutoff time (the W and X keys enable changing position of the cursor, and the
numerical keys – entering a new time setting), press the [#] again to activate the output.
Activation of the output is signaled by four short beeps and one long beep. You can disable
the output by pressing any numerical key.
Controlling the BI SWITCH type of output
The output status is indicated on the display in the following manner:
- output inactive (disabled),
- output active (enabled).
The output state can be toggled by using the [#] or X key. To change over the output state to
the inactive one, press any numerical key. Activation of the output is signaled by four short
beeps and one long beep. Deactivation of the output is signaled by three short beeps.
Controlling the R
EMOTE SWITCH type of outputs
The control is effected by means of the [#] or X key. Pressing the key will activate the output
for a preprogrammed period of time or toggle the status of the output. It depends on the
output settings. The R
EMOTE SWITCH type of output will work similarly as the MONO SWITCH, if
its preset operation time is different from 0, or as the BI SWITCH, if the preset operation time is
equal to 0 or the L
ATCH option has been enabled. Also, you can always disable the output by
pressing any numerical key.
In case of the R
EMOTE SWITCH type of outputs, the output status can also be displayed on the
basis of zone status, hence the meaning of displayed symbols depends on output settings:
- output inactive (off) or zone non-violated (device controlled by output is inactive),
- output active (on) or zone violated (device controlled by output is active).
Note: If the output works in the same way as the MONO SWITCH, and its status is not
displayed on the basis of zone status, then repeatedly pressing the [#] or X key with
the output active will change the symbol displayed, but the output will remain active for
the preprogrammed period of time.
Controlling the SHUTTER UP and SHUTTER DOWN type of outputs
The SHUTTER UP and SHUTTER DOWN type of outputs are always programmed as consecutive
and in pairs. Displayed on the list of outputs is only the name of output programmed as