User manual

User Manual INTEGRA 64
11. APPENDIX C
This appendix contains typical descriptions of the operations to be carried out when calling
some user functions. Since the user function menu depends on programming by the
installer and particular user authority level, the following keypad displayed texts may look
different in practice and are shown here for reference only.
Example 1: ARMING (part I: [CODE][#])
- partition No. 2 named “Book-keeping", belonging to Object 1; user – the master user.
[1][1][1][1][#] Enter the factory default code for Object 1 administrator. You can enter the code of any user
authorized to arming/disarming in Partition 2.
This message is displayed when the user has the right to change the code and should make this change (see
User Manual, INTEGRA, description of function Change own code).
[#] Confirm the message.
By pressing [#] or X
, all partitions accessible to the user will be armed.
Note: If some of partitions accessible to the user are already armed, the control panel will only make available
the functions of disarming, but if just one partition is armed, it will be disarmed. To arm the remaining
partitions, first call the user function menu by typing [CODE][
*
] (see continuation of the example:
ARMING (part II) below).
T
Indicate Arm selected function.
X or [#]
Call the function
.
T or S Scroll through the list with partition names. Press one of these keys as many times as needed to
display the name of the partition required (partition 2 – Book-keeping).
After the function is called, the control panel will display names of partitions (factory set or entered by the
installer), which may be armed by the user. Press key X
to move to the graphic mode of
partition
selection.
[3] Indicate the partition selected for arming (
mark at the right-hand side of the display) using any
numeric key.
You may select for arming (mark) any number of partitions accessible to you. Also, you may cancel marking for
partitions selected earlier.
[#] End of selection and arming of all marked partitions.
When this message appears, countdown of the time for leaving is started in the armed partitions.
GRAPHIC MODE
There are two ways of selecting the partitions to be armed:
• using names – as described above,
Change your code
(press #)
Á
Arm all
Arm selected
What to arm:
Storeroom
What to arm:
Book-keeping
System armed