User manual

User Manual INTEGRA 70
13. HISTORY OF THE MANUAL UPDATES
Given below is a description of changes as compared with the manual for the control panel
with firmware in version v1.00.
DATE
FIRMWARE
VERSION
INTRODUCED CHANGES
2005-09 1.03
• Supplemented information on the ETHM-1 module (p. 6, 57).
• Added information on optional blocking of keypad (p.
12), partition keypad (p. 19)
and code lock (p.
25) after three wrong codes are entered.
• Modified section on the proximity card/DALLAS chip readers (p.
26).
• Added information on optional blocking of the proximity card/DALLAS chip reader
after three attempts to read in a card/chip unknown to the control panel
(p.
16, 26).
• Described modification of the method to change the prefix length (s.
28).
• Added section "Proximity cards/DALLAS chips" (p.
28).
• Changed and supplemented section "System armed mode " (p.
34).
• Added information on inactive downloading function being automatically quitted by
the control panel (p.
39).
• Supplemented the diagram showing the user function menu (p.
40).
• Description of the "Tests" user function supplemented with information on new
functions: "Radio devices (p.
56) and "IP/MAC ETHM-1" (p. 57).
• Supplemented the list of messages displayed in the keypad when viewing the
troubles (p.
61).
2006-07 1.04
• Manual supplemented by adding information on icons introduced in keypads,
partition keypads and code locks (instead of previous verbal descriptions of
LEDs).
• In connection with offer extension and changes in trade names of keypads, and
also appearance of new functions, sections on LCD keypads (p.
8–16), partition
keypads (p.
16–20) and code locks (p. 24–25) have been modified.
• Supplemented information on cases when partitions cannot be armed (p.
34).
• Added information on optional trouble review prior to arming (p.
35).
• Modified and supplemented description of viewing violated/bypassed zones
before arming (p.
35).
• Added information on optional reduction of the exit delay time (p.
35).
• Added description of alarm clearing methods (p.
37).
• Added information on viewing cleared alarms (p.
37).
• Added information on reset of messaging to other users after reception of the
message by the indicated user (p.
38)
• Supplemented diagram showing the user functions menu (p.
40).
• Added descriptions of new user functions: "View cleared alarms " (p.
44), "Restore
system" (p.
44) and "Open door" (p. 57).
• Changed description of the user function "Change options”, by modifying
information on function "Outputs chime” (p.
53).
• Changed description of the user function "Tests" by deletion of information on the
functions "LCD keypads" and "Expanders", by modifying information on functions
"Partitions" (p.
55) and "Zone test" (p. 56) and by adding information on functions
"Messaging test" (p.
56) and "Module versions" (p. 57).
• Changed and supplemented description of the user function "Outputs control"
(p.
57).
• Added section regarding CLC/TS 50131-3 requirements (p.
60).
• Supplemented list of messages displayed on keypad when viewing the troubles
(p.
61).
2007-08 1.05
• Information on signaling of entry delay countdown in partition keypads has been
modified (p.
18).
• Information on INT-SCR-BL multifunctional keypad has been added and operating
modes available for it have been described (p.
20-24).
• Information has been added regarding modification of the arming procedure in
LCD keypad in case when arming was impossible (p.
34).
• Added information on defining the armed mode which is to be enabled by means