User's Manual

SATELLINE-M3-TR1
User Guide, Version 3.0
25
 Pacific Crest 4-FSK
 Pacific Crest GMSK
 TRIMTALK GMSK, RX fitted to Pacific Crest transmitters
 TRIMTALK GMSK, RX fitted to Trimble transmitters
 PCC-FST
o Addressing:
o When TX address is selected ON, then TX1 address is used like PDL Remote
address that is the destination address for the transmitted messages.
Default value is 0x00FF (=255) (note the hexadecimal format of the setting)
o When RX Address is selected ON, then RX1 address is used like PDL Local
address
Default value is 0x0000 (=0) (note the hexadecimal format of the setting)
Note: Addresses are NOT applicable in TRIMTALK 450s mode so SATELLINE modems
must have their RX/TX addresses OFF with Option3.
The configuration tools and settings are different between SATELLINE and Pacific Crest modems:
o Pacific Crest modems are configured via the serial port using PDLCONF Windows
TM
program that sends binary control messages to the serial port of the modem.
o SATELLINE-M3-TR1 radio modem modules are configured via the serial port using any
ordinary terminal program or SATEL Configuration Manager PC-program.
The table below shows the analogy of settings between Pacific Crest and SATELLINE radio
modems (status in firmware version v3. 46.3).
Pacific Crest setting
Corresponding SATELLINE-M3-TR1 setting
Identification: Owner
(not implemented)
Identification: Channel Bandwidth
Channel spacing
Identification: RF Power
TX power
Radio Link: Channel Selection Type (Manual)
Radio frequency
Radio Link: Current Channel
Radio frequency
Radio Link: Link Rate
The fixed link rates are:
Option 2 & 3: 9600bps@25kHz / 4800bps@12.5kHz
Option 1: 19200bps@12.5kHz / 9600bps@12.5kHz
Radio Link:Modulation Mode
Compatibility->PCC-4FSK
Compatibility->PCC-GMSK
Compatibility->TRIMTALK GMSK
Radio Link:Scrambling
ON by default
Radio Link:Transmit Retries
(not implemented)
Radio Link:TX ACK Timeout
(not implemented)
Radio Link:Csma Monitoring
Priority (RX=ON, TX=OFF) Default: RX
Radio Link: AutoBase/AutoRover
(not implemented)
Radio Link:Digisquelch
Signal threshold
Radio Link:Forward Error Correction
ON by default using Option 1, 2, 3
(Note: SATELLINE-M3-TR1 FEC must be OFF!)
Radio Link:Local Address (0 by default)
Primary RX address (RX1) (OFF by default)
Radio Link:Remote Address (255 by default)
Primary TX address (TX1) (OFF by default)
Serial Interface:Protocol Mode
Radio compatibility:
Options 1 and 2 = Transparent w/EOT Timeout
Option 3 = TRIMTALK 450s, RX fitted to PCC
Option 4 = TRIMTALK 450s, RX fitted to Trimble
Option 5 = PCC Transparent FST
Serial Interface:BREAK to Command
(not implemented)
Serial Interface:Modem Enable: Yes
(not applicable)