User's Manual
Table Of Contents
- IMPORTANT NOTICE
- RESTRICTIONS ON USE
- PRODUCT CONFORMITY
- WARRANTY AND SAFETY INSTRUCTIONS
- TABLE OF CONTENTS
- INTRODUCTION
- 1 TECHNICAL SPECIFICATIONS
- 2 OPERATING VOLTAGE
- 3 SERIAL INTERFACE
- 4 USER INTERFACE
- 5 RF INTERFACE
- 5.1 Transmitter
- 5.2 Receiver
- 5.3 Priority RX/TX
- 5.4 Error correction
- 5.5 Error checking
- 5.6 User data whitening
- 5.7 Pacific Crest and TRIMTALK compatibility
- 6 TRANSPARENT DATA TRANSMISSION
- 7 SETTINGS
- 8 SW-RELATED COMMANDS AND OPTIONS
- 9 ACCESSORIES
- 10 APPENDIX A
- 11 APPENDIX B
SATELLINE-M3-TR1
User Guide, Version 3.0
34
o Save changes by pressing ”E” in the main menu. If you don’t want to save changes, press
”Q”.
o Disconnect PROG-pin from ground (if using the NARS-1F-4A adapter, slide the switch
upwards), the radio modem should now return to the Data Transfer Mode.
When creating a test connection, you can also use the Windows-based SATEL Configuration
Manager, (available for free from authorised SATEL dealers or directly from SATEL Customer
Support).
***** SATELLINE *****
FW:06.16.3.xx.xx / HW: SPL0005x / PV: 0x.0x / IM: 0x / PWR:6-30V
S/N: yywwxxxxx
--------------------------------------------------------------------------------
Current settings
----------------
1) Radio frequency TX: 438.00000 MHz / RX: 438.00000 MHz / Ref freq: 438.00000 MHz /
Spacing 12.5 kHz
2) Radio settings Tx power 1000 mW / Signal threshold -112 dBm / FCS OFF /
TX start delay 0 ms / Compatibility Satel 3AS / Call sign OFF
3) Addressing RX address OFF / TX address OFF /
RX address to RS port OFF / TX address autoswitch OFF
4) Serial port 1 ON / 9600 bit/s / 8 bit data / None parity / 1 stop bit
5) Serial port 2 OFF / 9600 bit/s / 8 bit data / None parity / 1 stop bit (RS-232)
6) Handshaking CTS Clear to send / CD RSSI-threshold /
RTS Ignored / Pause length 3 bytes
7) Additional setup Error correction OFF / Error check OFF / Repeater OFF /
SL-commands ON / Priority TX / Full CRC16 check OFF /
User Data Whitening OFF
8) Routing OFF
9) Tests OFF
A) Restore factory settings
E) EXIT and save settings
Q) QUIT without saving
Enter selection >
More information at www.satel.com
NOTE! To switch the radio modem back into Data Transfer Mode the MODE-pin must be
disconnected from ground (GND).