User's Manual
Table Of Contents
- IMPORTANT NOTICE
- RESTRICTIONS ON USE
- PRODUCT CONFORMITY
- WARRANTY AND SAFETY INSTRUCTIONS
- TABLE OF CONTENTS
- INTRODUCTION
- 1 TECHNICAL SPECIFICATIONS
- 2 OPERATING VOLTAGE
- 3 SERIAL INTERFACE
- 4 USER INTERFACE
- 5 RF INTERFACE
- 5.1 Transmitter
- 5.2 Receiver
- 5.3 Priority RX/TX
- 5.4 Error correction
- 5.5 Error checking
- 5.6 User data whitening
- 5.7 Pacific Crest and TRIMTALK compatibility
- 6 TRANSPARENT DATA TRANSMISSION
- 7 SETTINGS
- 8 SW-RELATED COMMANDS AND OPTIONS
- 9 ACCESSORIES
- 10 APPENDIX A
- 11 APPENDIX B
SATELLINE-M3-TR1
User Guide, Version 3.0
35
7.1.2 Restoring factory settings
The settings that the modem was delivered from the factory are called “factory settings”.
“Restore factory settings” selection is achieved by selecting “A” from the menu list.
Factory settings are restored by selecting ”Y” (YES). By pressing “N” (NO) or any other button no
changes is done and current settings will remain active. The modem will ask this question twice
to make ensure that this is a valid command.
Enter selection >A
Restore factory settings
------------------------
Do you want to restore factory settings? (Y/N)>
PORT 1 of the radio modem is connected to a terminal device or a PC, which is in terminal
emulation state. (This can be accomplished by using a suitable program such as the SaTerm
program or the Windows™ Hyper Terminal program). Check the wiring of the serial port
connection cable. Terminal device serial port settings must be set to 9600 bps, N, 8, 1 (data
transfer speed 9600 bps, no parity, data length 8 bits and one (1) stop bit). MODE-pin (pin 12
of the D-connector of the radio modem) is then connected to ground (GND). Following this the
radio modem will transmit the following message to the terminal (certain configuration settings
might differ from the ones shown):
***** SATELLINE *****
FW: 06.16.x.xx.xx / HW: SPL0005x / PV: 00.xx / IM: 01 / S/N: YYMMxxxx
-----------------------------------------------------------------------------------
Current settings
----------------
1) Radio frequency TX: 438.0000 MHz / RX: 438.0000 MHz /
Ref freq: 438.0000 MHz / Spacing 25 kHz
2) Radio settings Tx power 1000 mW / Signal threshold -115 dBm / FCS OFF /
TX start delay 0 ms / Compatibility Satel 3AS / Call sign OFF
3) Addressing RX address OFF / TX address OFF /
RX address to RS port OFF / TX address autoswitch OFF
4) Serial port 1 ON / 9600 bit/s / 8 bit data / None parity /
1 stop bit
5) Serial port 2 OFF / 9600 bit/s / 8 bit data / None parity /
1 stop bit (RS-422)
6) Handshaking CTS Clear to send / CD RSSI-threshold /
RTS Ignored / Pause length 3 bytes
7) Additional setup Error correction OFF / Error check OFF / Repeater OFF /
SL-commands OFF / Priority TX / Full CRC16 check OFF /
User Data Whitening OFF
8) Routing OFF
9) Tests OFF
A) Restore factory settings
B) INFO
E) EXIT and save settings
Q) QUIT without saving
Enter selection >