User's Manual
Table Of Contents
- IMPORTANT NOTICE
- RESTRICTIONS ON USE
- PRODUCT CONFORMITY
- WARRANTY AND SAFETY INSTRUCTIONS
- TABLE OF CONTENTS
- INTRODUCTION
- 1 TECHNICAL SPECIFICATIONS
- 2 OPERATING VOLTAGE
- 3 SERIAL INTERFACE
- 4 USER INTERFACE
- 5 RF INTERFACE
- 5.1 Transmitter
- 5.2 Receiver
- 5.3 Priority RX/TX
- 5.4 Error correction
- 5.5 Error checking
- 5.6 User data whitening
- 5.7 Pacific Crest and TRIMTALK compatibility
- 6 TRANSPARENT DATA TRANSMISSION
- 7 SETTINGS
- 8 SW-RELATED COMMANDS AND OPTIONS
- 9 ACCESSORIES
- 10 APPENDIX A
- 11 APPENDIX B
SATELLINE-M3-TR1
User Guide, Version 3.0
37
7.4 Basic configuration and installation
The radio modem is shipped with the following default settings (unless otherwise specifically
ordered):
DEFAULT VALUES OF THE ADJUSTABLE SETTINGS
( the user can change these settings later on )
Setting
Default value
Notes
Radio frequency
Operating TX frequency
438.000 MHz
Range: 403-473 MHz
Operating RX frequency
438.000 MHz
Range: 403-473 MHz
Reference Frequency
438.000 MHz
Range: 403-473 MHz
Channel Spacing
25 kHz
Range:12.5 kHz, 20 kHz or 25 kHz (*
Radio settings
Tx Power
1000 mW
Range: 100, 200, 500 or 1000 mW
Signal threshold
-115 dBm
-80 … -118 dBm
FCS
OFF
ON/OFF
TX Start Delay
0 ms
0-65535 ms
Radio Compatibility
SATEL 3AS
SATELLINE-3AS, Option1=PCC 4-FSK,
Option 2=PCC GMSK, 3=TrimTalk 450s (P),
4=TrimTalk450s (T), 5=PCC-FST
Addressing
RX Address
OFF
ON/OFF
TX Address
OFF
ON/OFF
RX addressing to RS port
OFF
ON/OFF
TX address auto switch
OFF
ON/OFF
Serial port 1
Status
ON
ON/OFF
Interface
RS-232
Fixed
Data speed
9600 bps
300, 600, 1200, 2400, 4800, 9600,
19200, 38400 bps
Data bits
8
7, 8, 9.
Parity bits
None
None, Even, Odd
Stop bits
1
1, 2
Serial port 2
Status
OFF
ON/OFF
Interface
LVTTL
RS-232/422, TTL, LVTTL
Data speed
9600 bps
300, 600, 1200, 2400, 4800, 9600,
19200, 38400 bps
Data bits
8
7, 8, 9
Parity bits
None
None, Even, Odd
Stop bits
1
1, 2
Handshaking
Handshaking lines apply to the DATA-port
CTS
Clear to send
Clear to send, TX buffer state
CD
RSSI threshold
RSSI- threshold, Data on channel,
Always ON