User's Manual
Table Of Contents
- IMPORTANT NOTICE
- RESTRICTIONS ON USE
- PRODUCT CONFORMITY
- WARRANTY AND SAFETY INSTRUCTIONS
- TABLE OF CONTENTS
- INTRODUCTION
- 1 TECHNICAL SPECIFICATIONS
- 2 OPERATING VOLTAGE
- 3 SERIAL INTERFACE
- 4 USER INTERFACE
- 5 RF INTERFACE
- 5.1 Transmitter
- 5.2 Receiver
- 5.3 Priority RX/TX
- 5.4 Error correction
- 5.5 Error checking
- 5.6 User data whitening
- 5.7 Pacific Crest and TRIMTALK compatibility
- 6 TRANSPARENT DATA TRANSMISSION
- 7 SETTINGS
- 8 SW-RELATED COMMANDS AND OPTIONS
- 9 ACCESSORIES
- 10 APPENDIX A
- 11 APPENDIX B
SATELLINE-M3-TR1
User Guide, Version 3.0
40
The radio modem will acknowledge all commands by returning an "OK" (command carried out
or accepted) or the requested value, or an "ERROR" (command not carried out or interpreted as
erroneous) message.
8.4.1 Changing parameters using the SL-commands
The controlling terminal device can change the configuration settings of a radio modem. This is
accomplished with the help of SL-commands, which can be used during data transfer. SL-
commands can be used to change e.g. the frequency or addresses. It is also possible to
interrogate a radio modem in order to gain information concerning current settings that are in
use. The terminal device is either a PC or a programmable logic (PLC) together with suitable
(terminal) program. SL-commands must be enabled (in the set-up) before they can be used.
More information at www.satel.com