User's Manual
Table Of Contents
- IMPORTANT NOTICE
- RESTRICTIONS ON USE
- PRODUCT CONFORMITY
- WARRANTY AND SAFETY INSTRUCTIONS
- TABLE OF CONTENTS
- INTRODUCTION
- 1 TECHNICAL SPECIFICATIONS
- 2 OPERATING VOLTAGE
- 3 SERIAL INTERFACE
- 4 USER INTERFACE
- 5 RF INTERFACE
- 5.1 Transmitter
- 5.2 Receiver
- 5.3 Priority RX/TX
- 5.4 Error correction
- 5.5 Error checking
- 5.6 User data whitening
- 5.7 Pacific Crest and TRIMTALK compatibility
- 6 TRANSPARENT DATA TRANSMISSION
- 7 SETTINGS
- 8 SW-RELATED COMMANDS AND OPTIONS
- 9 ACCESSORIES
- 10 APPENDIX A
- 11 APPENDIX B
SATELLINE-M3-TR1
User Guide, Version 3.0
5
WARRANTY AND SAFETY INSTRUCTIONS
Read these safety instructions carefully before using the product:
-Warranty will be void, if the product is used in any way that is in contradiction with the
instructions given in this manual, or if the radio modem housing has been opened or
tampered with.
-The radio modem is only to be operated at frequencies allocated by local authorities,
and without exceeding the given maximum allowed output power ratings. SATEL and its
distributors are not responsible, if any products manufactured by it are used in unlawful
ways.
-The devices mentioned in this manual are to be used only according to the instructions
described in this manual. Faultless and safe operation of the devices can be guaranteed
only if the transport, storage, operation and handling of the devices is appropriate. This
also applies to the maintenance of the products.
-To prevent damage it is recommended that both the radio modem and any terminal
devices are switched OFF before connecting or disconnecting the serial connection
cable. It should be ascertained that different devices used have the same ground
potential. Before connecting any power cables the output voltage of the power supply
should be checked.
NOTE!
When selecting a suitable location for the radio modem it must be ensured that no water can
get into the radio modem under any conditions. Direct sunlight is also to be avoided. It is not
recommendable to install the radio modem on a strongly vibrating surface. Suitable
dampening and/or isolation materials should be used in cases where the installation surface
will be subjected to vibration.