Integration Guide

SATELLINE-M3-TR3
and –TR4
Integration Guide, Version 1.6
26
9 APPENDIX
9.1 SL COMMANDS
Category
Command
Description
Response
Addressing
SL#A?
Show all addresses (RX1, RX2, TX1,
TX2)
"xxxx,yyyy,zzzz,vvvv"
Addressing
SL#A=xxxx, yyyy,
zzzz,vvvv
Set RX/TX addresses (RX1, RX2,
TX1, TX2)
"OK" or "ERROR"
Addressing
SL#I?
Get primary addresses (TX1, RX1)
"xxxx;yyyy"
Addressing
SL#I=xxxx
Set all addresses (RX1, RX2, TX1,
TX2) to value xxxx [0000....ffff]
"OK" or "ERROR"
Addressing
SL#P?
Get primary transmit address (TX1)
and primary receive address (RX1)
"xxxx;yyyy"
Addressing
SL#P=xxxx;yyyy
Set primary transmit address (TX1)
to value xxxx and primary receive
address (RX1) to value yyyy
[0000....ffff]
"OK" or "ERROR"
Addressing
SL#Q?
Get TX address mode
"0" = TX address OFF
"1" = TX address ON
Addressing
SL#Q=x
Set TX address ON/OFF. Values of
x are:
"0" = TX address OFF
"1" = TX address ON
"OK" or "ERROR"
Addressing
SL#R?
Get primary receive address (RX1)
"yyyy"
Addressing
SL#R=xxxx
Set receive addresses (RX1, RX2) to
value xxxx [0000....ffff]
"OK" or "ERROR"
Addressing
SL#S?
Get secondary transmit address
(TX2) and secondary receive
address (RX2)
"xxxx;yyyy"
Addressing
SL#S=xxxx;yyyy
Set secondary transmit address
(TX2) to value xxxx and secondary
receive address (RX2) to value yyyy
[0000....ffff]
"OK" or "ERROR"
Addressing
SL#T?
Get primary transmit address (TX1)
"xxxx"
Addressing
SL#T=xxxx
Set transmit addresses (TX1, TX2)
to value xxxx [0000....ffff]
"OK" or "ERROR"
Addressing
SL#W?
Get RX address mode
"0" = RX address OFF
"1" = RX address ON
Addressing
SL#W=x
Set RX address ON/OFF. Values of
x are:
"0" = RX address OFF
"1" = RX address ON
"OK" or "ERROR"
ChannelList
SL$A=1
Go to channel list default channel
"OK" or "ERROR"