User's Manual

SATELLINE-4Pro
User Guide v0.93 DRAFT
28
Radio Link: AutoBase/AutoRove
r
(not implemented)
Radio Link:Digisquelch Signal threshold
Radio Link:Forward Error Correction ON by default using Option 1, 2, 3
(Note: SATELLINE-4Pro FEC must be OFF!)
Radio Link:Local Address (0 by default) Primary RX address (RX1) (OFF by default)
Radio Link:Remote Address (255 by
default)
Primary TX address (TX1) (OFF by default)
Serial Interface:Protocol Mode Radio compatibility:
Options 1 and 2 = Transparent w/EOT
Timeout
Option 3 = TRIMTALK 450s, RX fitted to PCC
Option 4 = TRIMTALK 450s, RX fitted to
Trimble
Option 5 = PCC Transparent FST
Serial Interface:BREAK to Command (not implemented)
Serial Interface:Modem Enable: Yes (not applicable)
Serial Interface:Soft Break Enable (not implemented)
Serial Interface:EOT value (in 0.01s
units)
Pause length (in serial port byte intervals)
Serial Interface:Digipeater
Delay(in0.01s units)
(not implemented)
Serial Interface:Local Node Repeate
r
(not implemented)
Frequency Table Radio frequency
Data Security Code (must be 0=not
used)
(not implemented)
Potential conflicts:
- Pacific Crest Local/Remote addresses are supported in the firmware versions starting
from v3. 46.3
- Repeater function is supported only in the firmware versions starting from v3. 46.3
- Error check and Full CRC16 check must be OFF in SATELLINE modem
- FCS (Free Channel Scanning) feature is not supported by Pacific Crest radios
- Message Routing is not supported by Pacific Crest radios
- SATELLINE RX/TX addressing does not use ARQ scheme like Pacific Crest radios.
- Pac Crest Transparent FST protocol supported starting from firmware version 3.57
7.8.4 Repeater function
The implemented Pacific Crest/TRIMTALK modes support also the repeater function. The repeater
function is configured either by using the SL commands:
 ”SL@M=R” (Repeater ON)
 ”SL@M=O” (Repeater OFF)
Note 1. The repeater modem passes TRIMTALK messages also to its serial port unlike for example
Pacific Crest PDL modems.