User's Manual

SATELLINE-4Pro
User Guide v0.93 DRAFT
39
9.1.2 CHECKING/CHANGING THE REFERENCE FREQUENCY
Press SETUP, set cursor at the Radio frequency and
press Select.
>Radio frequency
Radio settings
Addressing
Port 1
Port 2
Handshaking
Additional
Tests
Factory setup
Contrast
EXIT▲▼Select
Press ▲ o
r
▼ until the cursor points at “Reference
freq” selection and press ”Change”.
TX & RX freq
TX freq
RX freq
> Reference freq
Ch Spacing
Back ▼ Change
Band 1 limits are shown.
By pressing ▼ again the display will show Band 2
limits (these values cannot be changed).
Band 1 limits
Lo 403.00000 MHz
Hi 473.00000 MHz
Cancel ▲▼ Set
To activate Reference frequency window, press Set.
Band 2 limits
Lo 467.2000 MHz
Hi 469.2000 MHz
Cancel ▲▼ Set
The display will now show
New Ref freq
438.00000 MHz
The cursor > will now blink under the first digit of
the value indicating the (this first digit cannot be
edited). To move onto the next digit, press ”Next”.
Previous steps are repeated four (4) times.
Press ▲ or ▼, until the last changeable digit has
the desired value and confirm changes by pressing
”Set”. The following information will be displayed
for a few seconds.
Ch accepted
468.52500 MHz
The radio modem will acknowledge changes if
they are between band limits. The display will
return automatically to display the main menu (if
the entered frequency is not acceptable an error
message will be displayed).
New common freq
468.52500 MHz
Cancel ▲ ▼ Next