User's Manual

SATELLINE-4Pro
User Guide v0.93 DRAFT
43
9.1.5 Changing serial port settings (Port 1)
Press ▲ or ▼ until the cursor >
points to the desired port (in this
example to Port 1) and move on
to the submenu by pressing
”SELECT”.
Radio frequency
Radio settings
Addressing
>Port 1
Port 2
Handshaking
Additional
Tests
Factory setup
LCD-Contrast
Exit ▲ ▼ Select
Press ▲ or ▼ until the cursor >
points to the setting to be
modified and then press
”CHANGE”.
ON
>19200 bit/s
8 bit data
None parity
1 stop bit
Back ▲▼ Change
MODIFICATION OF DATA TRANSFER SPEED:
Press ▲ or ▼ until the cursor > points to the desired
data transfer speed value (X bit/s). Confirm the selection
by pressing ”SET”. The display will return to the previous
(higher) level submenu.
NOTE: The starting position of the cursor indicates the
previously set value.
9600 bit/s
>19200 bit/s
38400 bit/s
57600 bit/s
115200 bit/s
Cancel ▲▼ Set
MODIFICATION OF THE NUMBER OF DATA BITS:
Press ▲ or ▼ until the cursor > points to the desired
number of data bits (8 bit data length only). Confirm the
selection by pressing ”SET”. The display will return to
the previous (higher) level submenu.
NOTE: The starting position of the cursor indicates the
previously set value.
>8 bit data
Cancel ▲ ▼Set
MODIFICATION OF PARITY BITS:
Press ▲ or ▼ until the cursor > points to the desired
parity bit status. Confirm the selection by pressing
”SET”. The display will return to the previous (higher)
level submenu.
NOTE 1: The starting position of the cursor indicates
the previously set value.
NOTE 2: If the number of data bits is set to 9, the value
of parity bits must be set to NONE (none parity).
>None parity
Even parity
Odd parity
Cancel ▲▼ Set
NOTE!
The radio modem has one serial port, PORT 1 which complies with the RS-232 standard. PORT
2 is not in use and the settings of serial PORT 2 cannot be changed.