User's Manual

SATELLINE-4Pro
User Guide v0.93 DRAFT
45
9.1.7 Selecting special functions
Press ▲ ▼ until the cursor > points to
“Additional” selection and press ▼
”SELECT” to move on to the submenu.
Radio frequency
Radio settings
Addressing
Port 1
Port 2
Handshaking
>Additional
Test
Factory setup
LCD-Contrast
Exit ▲▼ Select
Press ▲ o
r
▼ until the cursor > points
to the setting to be modified. Press
”CHANGE” to toggle the status of the
said parameter from ”ON” to ”OFF”
and vice versa. Press ”CHANGE” until
the parameter has the desired status.
Repeat for all special functions to be
modified and finally confirm all changes
by pressing ”BACK”. The display will
return to the previous (higher) level
submenu.
>Error corr. OFF
Error check OFF
Repeater OFF
SL-commands OFF
Priority TX
Full CRC16 OFF
Data whiten OFF
Back ▲▼ Change
9.1.8 Activating tests
Press ▲ or ▼ until cursor > points to
“Tests” selection and press ”SELECT” to
move on to the submenu.
Radio frequency
Radio settings
Addressing
Port 1
Port 2
Handshaking
Additional
>Tests
Factory set-up
LCD-Contrast
Exit ▲▼ Select
Press ▲ o
r
▼ until cursor > points to
the test that is to be initiated. Press
”CHANGE” to toggle the status of the
selected test from ”ON” to ”OFF” and
vice versa. After the tests have been set
to desired states confirm all changes by
pressing ”BACK”. The display will return
to the previous (higher) level submenu.
When the tests have been switched ON
the TD led is green. Test signal will be
activated by pressing BACK and saving
the setting.
>Short Block OFF
Long Block OFF
Back ▲ ▼ Change