User's Manual

SATELLINE-4Pro
User Guide v0.93 DRAFT
54
Reception addressing has
been set OFF.
The radio modem will
transfer all received data
to the RS-232 interface.
Reception addressing has
been set OFF.
The radio modem will
consider the characters of
the address as a part of the
data and will send all the
characters to the RS-232
interface.
Reception addressing has
been set ON but there is no
address in the data packet.
Data will appear on the RS-
232 interface ONLY if the
first 2 characters of the data
match either of its own RX
address. The radio modem
will remove those 2
characters of data.
10.2.1 Connection between two points
When forming a connection between two points it is recommended that both the reception and
transmission addresses are identical in both radio modems. This is the easiest way to control
addresses and the risk caused by interference from other systems operating in the same area is
minimal.
Example: by setting all addresses of both radio modems to a value ´1234´, they will accept only
those messages which contain this address, and they will use this same value when transmitting
data.
If the channel is reserved for use only by the said network, or if the terminal devices are responsible
for addressing, it is not necessary to use addressing in the radio modems.
10.2.2 System of one base station and several substations
In systems with several substations, the base station must know to which substation each message
is intended, and from which substation each received message originates. Usually terminal devices
handle addressing completely, but it is also possible to use the addressing functionality of the radio
modems.