User guide

SATELLINE-3AS NMS / NMS Epic / NMS 869 / VHF
User Guide, Version 1.0
66
11
PROGRAMMING MODE (TERMINAL MENU)
11.1
Programming Mode
The basic settings of the radio modem are fully configurable in the Programming Mode . The
most recommended setup for changing parameters is CRS-9 cable, a power supply and the
SATEL NMS PC program. NARS-1F adapter contains a switch to enable easy shifting into the
Programming Mode . Other suitable terminal programs and cables may also be used.
The radio modem will shift into the Programming Mode by connecting the D-connector pin 12 to
ground (GND) potential. With NARS-1F adapter this can be accomplished by moving the slide
switch downwards.
In the Programming Mode , the radio modem will always use serial port P
PORT1
, with settings
9600 bps, N, 8,1 (data transfer speed 9600 bps, no parity, 8 data bits and 1 stop bit).
The radio modem will output the following Programming menu to the terminal (certain
configuration settings might differ from the ones shown):
-------------------------------------------------------------------------------
SATELLINE-3ASd NMS
SW: version 4.0.0.63
HW: AA01.03
RF: TC4n
Center frequency 468.200000 MHz / Channel spacing 25.000 kHz
SERIAL: 050112345 Name: MODEM_NAME
-------------------------------------------------------------------------------
1 ) Radio Settings TX frequency: 468.425000 MHz / TX Power 100 mW
RX frequency: 468.425000 MHz / FEC OFF /
RSSI Threshold -112 dBm / Error check OFF
TX delay 0 ms / Sync interval default / RX delay 0 ms
2 ) Protocol Mode Basic - RX Priority
3 ) Serial Port 1 DATA / RS232 / 19200 bps / 8 bit data / None parity /
1 stop bit
4 ) Serial Port 2 NMS / RS232 / 9600 bps / 8 bit data / None parity /
1 stop bit
5 ) Handshaking CTS Clear To Send / CD RSSI threshold / RTS Ignored /
Pause length 5 bytes
6 ) Additional Setup SL-commands ON / LCD read-only OFF
7 ) Tests & Counters
A ) Restore factory settings
E ) EXIT and save settings
Q ) QUIT without saving
Enter selection >