User guide

SATELLINE-3AS NMS / NMS Epic / NMS 869 / VHF
User Guide, Version 1.0
67
11.1.1
Changing the settings in the Programming Mode
• Connect cables (RS-232 cable to PC COM port, power supply cable to power supply).
• Switch on the PC and start SaTerm Lite program (or other terminal program).
• Open a terminal window and then choose ”Pr” (in case you are using some other terminal
program, set the serial port parameters of the program as follows: 9600 bits/s, 8 data bits,
no parity, 1 stop bit, which is always the default in Programming Mode ).
• Connect PROG pin to ground (if using the NARS-1F adapter, slide the switch downwards),
the radio modem shifts into the Programming Mode . The screen should look similar to the
one shown in the picture below.
• Make desired changes to the settings.
• Save changes by pressing ”E” in the main menu. If you don’t want to save changes, press
”Q”.
• Disconnect PROG pin from ground (if using the NARS-1F adapter, slide the switch upwards),
the radio modem returns to the Data Transfer Mode .