User guide

SATELLINE-3AS NMS / NMS Epic / NMS 869 / VHF
User Guide, Version 1.0
73
11.1.9
Restoring factory settings EXIT and save and QUIT without
saving -settings
The original settings of the radio modem can be restored by selecting “A” in the Main menu and
confirming ”Y” (YES) on the prompt. By pressing any other button current settings will remain
active. The modem will ask this question twice to make ensure that this is a valid command.
Restoring is confirmed by pressing ”Y” (Y=YES) or cancelled by pressing ”N” (N=NO). Also
pressing ”ESC” button at any point in the procedure will return the display to the previous (next
higher) menu level without restoring factory settings.
All modified settings must be saved into the permanent non-volatile memory of the radio
modem before switching out of the Programming Mode . Selecting the main menu selection E)
EXIT and save settings automatically saves the settings.
NOTICE! To switch the radio modem back into Data Transfer Mode the MODE-pin of the D-
connector
(
D-15
p
in 12
)
must be disconnected from
g
round
(
GND
)
.