User guide

SATELLINE-3AS NMS / NMS Epic / NMS 869 / VHF
User Guide, Version 1.0
77
13.1.2
Radio parameters
Command Description Response
SL@R? Get the minimum field strength (RSSI) of the last received
message.
Note: Value is available 5s after reception. SATELLINE-
3AS-NMS Epic returns the stronger value of two receivers.
"-xxx dBm", where xxx is
080….118
SL@P=xxxxx Set the RF output power, where xxxxx is the decimal value
of the intended power in mill watts. Only values
matching exactly the programmed power levels are
accepted.
"OK"
SL@P? Get RF output power. ”xxxxx mW”, where xxxxx
is a decimal value the
output power of the
transmitter.
SL@T=-xxx Set the minimum power level of the signal to be received
(="Signal Threshold level i.e. squelch), where xxx is a
decimal value of the new intended level in dBm.
"OK"
SL@T? Get current "Signal Threshold Level" "-xxx dBm", where xxx is
50….118
SL@F? Get the current RSSI. If no signal is being received, then
current noise level is shown.
"-xxx dBm", where xxx is
50….118