User's Manual

SATELLINE-3AS
User Guide, Version 2.2
70
9.2.1 Changing frequency (frequency of the active radio channel)
Press
ý
or
þ
until
the cursor >
points to “RF
frequency” –
selection and
press ”SELECT” to
move onto the
next submenu.
>RF frequency
Radio settings
Addressing
Port 1
Port 2
Handshaking
Additional
Tests
Factory setup
Contrast
EXIT ýþ SELECT
Press ”CHANGE”
if the frequency is
to be modified.
NOTE:
NOTE:NOTE:
NOTE: If you want to check possible
frequency band limits and the center
frequency (factory set values), press 
and follow instructions given on page 66
(Checking the center frequency).
Active channel
468.5000 MHz
BACK þ Change
The cursor > will now blink under the
first digit of the value indicating the
center frequency (this first digit cannot
be edited). To move onto the next digit,
press ”NEXT”.
CF 468.5000 MHz
>468.2000 MHz
^
CANCEL þ Next
Press
ý
or
þ
until the said digit has
reached the desired value. Press ”NEXT”
to move on to the next digit and repeat
the above-described steps.
CF 468.5000 MHz
>468.5000 MHz
^
CANCEL ýþ next
Previous steps are repeated four (4)
times.
:
:
Press
ý
or
þ
, until the last changeable
digit has the desired value and confirm
changes by pressing ”SET”.
CF 468.5000 MHz
>468.2000 MHz
^
CANCEL ýþ SET
The radio modem will acknowledge
changes if they are within acceptable
limits (± 1 MHz from the center
frequency, and within optional band
limits) with a similar message as shown
on the right (frequency value depends
on entered value). The display will
return automatically to display the main
menu (if the entered frequency is not
acceptable an error message will be
displayed).
Ch accepted
>468.2000 MHz