User's Manual

SATELLINE-3AS
User Guide, Version 2.2
73
9.2.3 Changing addressing
Press ý or þ until
the cursor >
points to
“Addressing”
selection and
press ”SET-UP” to
move on to the
submenu.
RF frequency
Radio settings
>Addressing
Port 1
Port 2
Additional
Test
Factory setup
Contrast
EXIT ýþ Set-up
Select the desired
submenu (RX or TX
address) by
pressing
ý
or
þ
and finally press
”CHANGE”.
>RX addr OFF
TX addr OFF
BACK þ Change
Press ý or þ until the first digit of the
address has reached the desired value
and move on to the next digit by pressing
”NEXT”.
RX address
>0000 0000 OFF
^
CANCEL ýþ Next
Repeat the above described eight (8)
times.
:
:
Press NEXT again to jump to the toggle
field (ON/OFF) and change the status to
the desired value by pressing
ý
and
þ
until correct status is reached. Confirm
the new address and status (ON/OFF
state) by pressing ”SET”.
The display will return to the previous
(higher) level submenu.
RX Address
>0123 0123 ON
^
CANCEL ýþ SET
NOTE
NOTENOTE
NOTE: Both RX and TX address modifications are done in the same above described way.