User's Manual

SATELLINE-3AS
User Guide, Version 2.2
77
9.2.8 Restoring factory settings
Press
ý
or
þ
to move cursor >
to point to “Factory set-up”
selection and press ”SELECT” to
move on to the submenu.
RF frequency
Radio settings
Addressing
Port 1
Port 2
Additional
Test
>Factory setup
Contrast
CANCEL ýþ Select
Press ”YES” and all radio
modem configuration settings
will return to factory settings.
NOTE:
NOTE:NOTE:
NOTE: The display will show
the question two (2) times to
make sure that restoring factory
settings is actually intended.
Do you want to
restore factory
settings?
NO YES
9.2.9 Adjusting the contrast of the LCD-display
Press
ý
or
þ
to move the cursor
> to point to “Contrast”
selection and press ”SELECT” to
move on to the submenu.
RF frequency
Radio settings
Addressing
Port 1
Port 2
Additional
Test
Factory set-up
>Contrast
CANCEL ýþ Select
The display will show the current
value of contrast. To modify
contrast setting press
”CHANGE”.
Display contr.
3
BACK Change
Press ý or þ until the cursor > points to the desired
contrast level value. Confirm selection by pressing
”SET”. The display will return to the previous (higher)
level submenu.
NOTE:
NOTE:NOTE:
NOTE: The modified contrast value will actually take
effect only after the radio modem is switched out from
Programming Mode back into Data Transfer Mode.
NOTE:
NOTE:NOTE:
NOTE: The starting position of the cursor indicates the
previously set value.
1
2
>3
4
5
CANCEL ýþ SET