User's Manual

SATELLINE-3AS
User Guide, Version 2.2
80
SL@T? Request of the current "Signal Treshold Level". Response is "-xxx dBm.
SL@D=x Sets the operational mode of the radio. The different values of x are:
”S” = Single Channel
”D” = Dual Channel
”R” Reverse Dual Channel
Note!
Note!Note!
Note! Use this command only, if the setup of the frequency bands matches the
Dual Channel operation.
SL@D? Request the operational mode of the radio. The response is one of the following:
”S” = Single Channel
”D” = Dual Channel
”R” Reverse Dual Channel
Note!
Note!Note!
Note! Use this command only, if the setup of the frequency bands matches the
Dual Channel operation.
9.3.4 Other functions
Command Effect and description of command
SL**> Save current settings as permanent settings
SL%V? Display software revision information (response ’Vn.nn’)
9.3.5 SATELLINE-2ASx/2ASxE compatible SL-commands
The commands listed in the table below are included only to ensure compatibility and their use
is not recommended in new networks. The commands do not need a CR-character (carriage
return) at the end of the command string.
Command Effect and description of command
SLHxx Set frequency xx channels above center frequency.
Frequency = Center frequency + xx*Channel spacing, where xx=[00…99]
SLLxx Set frequency xx channels below center frequency.
Frequency = Center frequency - xx*Channel spacing, where xx=[00…99]
SLAxx Set all addresses (RX1, RX2, TX1, TX2) to value xx, where xx=[00h...FFh]
SLTxx Set both transmit addresses (TX1, TX2) to value xx, where xx=[00h...FFh]
SLRxx Set both receive addresses (RX1, RX2) to value xx, where xx=[00h...FFh]
SLS0S Save current settings as permanent settings