Installation Instructions

DC POWER CEILING FAN WALL CONTROL MANUAL

ACTIVATING THE LEARNING PROCESS

1. After installation is complete, AC power is turned on within 30 seconds, press and

hold the LEARN button

for 3 seconds. The receiver will make sound, Bi, once. This

will indicate the receiver has learned the ID that was previously selected on the

transmitter. Then the wall transmitter can control the receiver.

2. If user cannot finish the setting

within the 30 seconds time frame, the main power

must be turned off and re-started again. This will reset the unit. Repeat step 1 until

the LEARNING feature is activated as indicated.

LIGHT FUNCTION SELECT SWITCH

If installed energy light onto ceiling fan, please set the “light function

select switch” “light function select switch” to O position. If installed

tungsten light onto ceiling fan, please set the “light function select switch”

to D position.

TRANSMITTER OPERATION

Press button 1~6 to set fan speed

Press this button to turn the fan off.

Press this button to set fan wind direction up or down.

ON/OFF—Press this button and release instantly to turn on or off the light.

DIMMER—Press and hold to dim or brighten lights to the desired level and

release. (Tungsten bulb only)

When pressing remote button, the LED indicator would be on.

TRANSMITTER

PAGE 1
DC POWER CEILING FAN WALL CONTROL MANUAL ACTIVATING THE LEARNING PROCESS 1. After installation is complete, AC power is turned on within 30 seconds, press and hold the LEARN button for 3 seconds. The receiver will make sound, Bi, once. This will indicate the receiver has learned the ID that was previously selected on the transmitter. Then the wall transmitter can control the receiver. 2.
PAGE 2
Installing transmitter to wall junction box: Remove wall plate, disconnect and remove the toggle switch from wall junction box. Using the wire connectors, make the electrical connections to the toggle switch of transmitter. Carefully push all connected wires inside wall switch box. Secure wall control unit with 2 screws previously removed. Face plate could be locked onto the transmitter.