Installation Instructions

CEILING FAN REMOTE CONTROL MANUAL

LEARNING PROCESS

NOTE：The Hand Held Remote Control System is equipped with a

learning frequency function which has code combinations to prevent

potential interference from other remote units. The frequency on your

Receiver and Transmitter units have been preset at the factory. We

recommend changing the frequency while installing your ceiling fan

instead of using the initial frequency set by the factory. Please use a

small size tool to change the code switch setting.

Step: 1 Open the remote battery cover and install DC12V,23A*1pc

battery

Step: 2 Within 30 seconds of turning the Receivers AC power ON.

Step: 3 Press and hold remote any key for over 3 seconds, once the

receiver has detected the frequency, Then fan turn off and light

blink 3 times. This will indicate the receiver has learned the

frequency that was previously selected on the transmitter.

NOTE: Remove the battery if not used for long periods of time to prevent damage to the hand held remote.

FUNCTIONS OF TRANSMITTER

：To turn the fan off.

: Turn on ceiling fan at high speed

Turn on ceiling fan at medium speed.

Turn on ceiling fan at low speed.

：Press and release immediately to turn on or off the light

DIMMER- Press and hold to dim or brighten lights to the

desired level and release.

When pressing remote button, the LED indicator would be on. If you press remote button and LED

indicator would not be on, you should change new DC12V,23A*1pc battery.

To assure continued FCC compliance:

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT

PAGE 1
CEILING FAN REMOTE CONTROL MANUAL LEARNING PROCESS NOTE：The Hand Held Remote Control System is equipped with a learning frequency function which has code combinations to prevent potential interference from other remote units. The frequency on your Receiver and Transmitter units have been preset at the factory. We recommend changing the frequency while installing your ceiling fan instead of using the initial frequency set by the factory. Please use a small size tool to change the code switch setting.
PAGE 2
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.