Installation Instructions

CEILING FAN REMOTE CONTROLLER MANUAL

LEARNING PROCESS

NOTE: The Hand Held Remote Control is equipped with a learning ID function which has code combinations to

prevent potential interference from other remote units.

Step: 1. Install the batteries AAA 1.5V*2 PCS in transmitter. Within 30 seconds of turning the

Receiver AC power ON, press the transmitter LEARN button

Step: 2. Hold LEARN button about 3 seconds, once the receiver has detected the

ID, the light of ceiling fan will be blinking twice and the fan turn on low speed. This

will indicate the receiver has learned the ID that was previously selected on the

transmitter.( The 0/1 switch on the back of the transmitter is in the "0" state, and

it can be directly controlled without pairing. The 0/1 switch is in the "1" state,

need to proceed learning.)

Note: After the AC power is on, do not press any other buttons on the transmitter

before learning ok. Because doing so will cause the procedure to fail.

After completing the steps above, you should be able to operate the ceiling fan

and light. If the ceiling fan is not responding to the transmitter, please turn the

power off to the receiver and repeat step 1 and 2.

Remove the batteries if not used for long periods of time to prevent damage to

the hand held remote. The batteries must be removed from the transmitter

before it is scrapped and the batteries shall be disposed of safety.

FUCNCTIONS OF TRANSMITTER

1. ：Turn on/off ceiling fan and light

: Turn on/off ceiling fan

3. FAN SPEED

Press

button to increase speed and LED bar will show at same time. All

LED is brighten for the highest speed. Press button to decrease speed.

: Turn on/off the light

5. LIGHT DIMMER:

—Press and hold to dim or brighten lights to the desired

level and release.

: Press this button to switch color temperature when the light is on.

PAGE 1
CEILING FAN REMOTE CONTROLLER MANUAL LEARNING PROCESS NOTE: The Hand Held Remote Control is equipped with a learning ID function which has code combinations to prevent potential interference from other remote units. Step: 1. Install the batteries AAA 1.5V*2 PCS in transmitter. Within 30 seconds of turning the Receiver AC power ON, press the transmitter LEARN button Step: 2.
PAGE 2
To assure continued FCC compliance: FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.