User's Guide

9. Make note of Blu+’s serial number.

10. Place Blu+ on the outside of the left ankle and wrap the strap around.

11. Insert two fingers inside the strap, opposite the device.

12. Look for the line on the strap that is two lines past the edge of Blu+.

13. Make a straight cut on the line, using STOP cutters only.

14. Insert the unclipped end into the wing to test the fit. Cut excess strap, if

necessary.

15. Attach clips to the end of the strap and press firmly into the wing.

If the clipped end cannot be inserted without pulling or bending, the strap has

been cut too short. Do not attempt to use it as the clips may not fully attach to

each side of the wing, causing false tamper alerts.

15. Firmly pull the strap to check the fit.

InstallationInstallation

Blu+ Installation (cont’d)