User's Guide

Blu+ Installation
1. Locate the strap, bridge clips, strap clips, cutter, and cutting plate.
2. Lay the square hole of the bridge clip across the center of Blu+.
3. Firmly press down on the bridge clip to fully insert its legs.
4. Once fully inserted, the bridge clip will lay flush against the Blu+ surface.
5. Insert one additional bridge clip.
6. Inspect the ends of the strap, making sure each end is cut straight and on a
line (if necessary, re-cut each end, on a sizing line).
7. Attach a pair of clips to one end of the strap. The ends of the clips must align
evenly with the end of the strap (not shorter or longer).
8. Insert the clipped end of the strap into a wing of the tag. Pull slightly to
ensure that it is secure.
InstallationInstallation
30