User's Guide

1. Cut the strap in the middle, leaving
an equal amount on both sides.
2. Insert the flathead screwdriver
underneath one bridge clip and
pry it from the wing.
3. Repeat for the other bridge clip.
4. Pull the strap out of the tag.
5. Inspect all parts for signs of
tampering.
6. Clean the lens and surrounding
area of any dirt build up.
7. If the enrollee has completed the
program, no signs of tampering
exist, and the unit is not needed
for evidence, place the device
back into inventory.
8. If you had to replace the strap or
device, repeat all preparation and
enrollment steps required for a
new enrollee (charge, GPS, install,
assign, verify GPS).
9. If you sense a problem with the
device, send it back to STOP.
UnenrollmentUnenrollment
Remove the Blu+ from the Enrollee
The following steps are to be completed after the unassignment.
41