FREEDOM 2 PORTABLE RESTROOM ASSEMBLY INSTRUCTION 2530 Xenium Lane North, Minneapolis, MN 55441 Telephone: 763-553-1900 Fax: 763-553-1905 800-328-3332 / www.satelliteindustries.com PN 14579/REV.
PARTS LIST PN 14579/REV, X page 2
INTRODUCTION Satellite portable restrooms must be assembled according to approved assembly procedures. Avoid variations in assembly procedures which could adversely affect product life and warranty. TOOLS: • • • 3/8” Hex Socket Driver #10 or 3/16”, and ¼” Drill Bit Drill • • All references to left, right, front and rear correspond to this illustration. Pop Rivet Gun Phillips and Flat Screwdrivers HELPFUL HINTS: • Keep panels out of direct sunlight. • Don’t open up all of your kit boxes.
2. DRILL DIMPLES ON EACH OF THE THREE SIDE PANELS. Using a ¼” bit drill through the appropriate dimples (14 on each panel). 3. ATTACH REAR PANEL TO FLOOR ANGLE Rivet the rear panel through the bottom two drilled dimples to the floor angle using #68 large flange aluminum rivets and back-up washers. 4. ATTACH RIGHT AND LEFT SIDE PANELS TO FLOOR/ANGLE Join the side panel to the rear panel using #68 large flange aluminum rivets and back-up washers, through the 5th hole from the bottom.
. ATTACH FRONT ASSEMBLY Using #68 aluminum large flange rivets and back-up washer attach the front to the panels through the 5th hole from the bottom, and the bottom 2 predrilled holes. NOTE THE PANELS MUST BE IN THE CORRECT INTERLOCK POSITION. 6. POSITIONING THE DOOR GAP: Install #68 stainless rivet thru .194" hole (at the bottom of the door jamb) into L bracket and place 3/16" washer on the outside and pop. Repeat for other side. 7.
9. ATTACH ROOF TO SIDE PANELS Drill all dimples on roof (24). Rivet the roof to the panel at the two center locations on each panel and front using #68 aluminum rivets and back-up washers. 10. TRANSFER DRILL AND INSTALL REMAINING RIVETS TO THE ROOF AND SIDE PANELS AND FRONT. First transfer drill using a ¼” drill bit both front side panel corners, CAUTION: Make sure the gap between the roof and panels is the same when transfer drilling the holes.
12. INSTALL LARGE FREEDOM2 TANK. 13. INSTALL TOILET SEAT. 14. INSTALL VENT SCREENS. PN 14579/REV, X Drill thru the panel using a ¼” drill bit.
15. INSTALL HANDRAILS. 16. INSTALL HANDLE AND DECAL 17.
18. INSTALL DOOR CLOSURE 19. OPTIONAL DOOR SWEEP. Center the door sweep on the door, keeping the door sweep about ½” from the floor. Transfer drill the holes through the door using a #10 drill bit. 20. PAPERGUARD. Drill four ¼” holes at dimples on left side panel, using (4) rivets and (4) push caps.