Instruction Manual

P/N 20963 REVA 6-11-10
INSTRUCTIONS HIGH RISE LIFT INSTALLATION
INTRODUCTION
Satellite portable restrooms and accessories must be assembled according to approved assembly procedures.
Variations in assembly could adversely affect product life and warranty.
HARDWARE:
TOOLS: *DRILL ELEC/CORDLESS, * 25/64 DRILL BIT, *1/2 SOCKET, *1/2 OPEN END WRENCH
*9/16 SOCKET, *9/16 OPEN END WRENCH, *ADJUSTABLE WRENCH
ASSEMBLY TIP: Use 25/64 drill bit to open holes if bolts don’t fit.
FASTEN SIDE STRAP/PIVOT STRAP ON OUTSIDE OF UNIT.
1. Locate (3) holes in floor and align with (3) holes in strap. Insert bolts from inside through holes and fasten with
nuts and tighten with 9/16 wrench. SEE FIG. A
2. Locate (2) holes in side horizontal angles and (2) holes in strap. Insert bolts from outside through holes and fasten
with nuts and tighten with 9/16 wrench. SEE FIG. B
3. Locate the (1) hole on top horizontal angle and (1) hole in top of strap. Insert bolts from outside through holes and
fasten with nuts and tighten with 9/16 wrench. SEE FIG. B
4. Repeat steps 1 thru 3 on opposite side.
FASTEN HIGH RISE CROSS LIFT TUBE
1. Fasten bolts and nuts as shown. SEE FIG. C
2530 Xenium Lane North, Minneapolis, MN 55441
Telephone: [phone] Fax: [phone]
800-328-3332 / www.satelliteindustries.com
FIG. C
FIG. A
FIG. B
INSERT BOLTS
FROM INSIDE
TOILET
BACK
FRONT
LOCATION OF
FASTENING
HOLES
LOCATION OF
FASTENING
HOLES
INSERT BOLTS FROM
OUTSIDE OF TOILET
NUTS ON
INSIDE OF
TOILET