User's Manual

September 2013 63-70-076-DOC-1 17
MARS-24ATRUser Manual
4.2.1 connecting to A poWer supply
Step 1: Connect a low voltage power pack to the unit.
The connection to the power source is enabled via a low voltage power pack.
The power cable is not supplied with the reader and is recommended to be purchased in the country of use.
Step 2:
Plug the power supply into AC power mains. LEDs will come on.
When power is applied to a MARS-24ATR Reader the LEDs on the Reader should operate as follows:
the red LED, blue LED and green LEDs will immediately come on; all LEDs will go off in about 1 minute
MARS-24ATR with the blue and green LEDs on
the blue LED will come on again in 1-3 seconds indicating that the unit is in an operational mode; the green
LEDs will be off
MARS-24ATR with the blue LED. The Reader is in an operational mode
once the unit is in an operational mode the blue LED will remain lit the green LEDs will flash every time a
tag/tags is/are successfully read. The red LED will indicate a fault of the unit. If it remains on then the unit
requires service.
LEDs are controlled by the MARS-24ATR reader software
•
•
•