Manualshelf

User's Manual

ManualsBrandsSato Vicinity ManualsElectronicsMARS-24 RFID DESKTOP READER
21222324252627282930
You can verify that the reader is connected by looking at the Network Connections window. You can open this
window from several places: Start -> Settings -> Control Panel -> Network Connections or My Computer ->
Other Places -> My Network Places -> View Network Connections.
Step 2: Make sure that the USB and power cables are plugged in. Turn on the reader. The Found
New Hardware dialog box will be displayed.
When a reader is connected to a host computer for the  rst time using a USB, there are a few steps to go
through before the ReaderManager is able to identify the new reader:
In Found New Hardware Wizard tick Yes, this time only to search for software and press Next.
In What do you want wizard to do? tick Install the software automatically and press Next.
Wait while the wizard installs the Linux USB Ethernet/RNDIS Gadget device driver. Ignore other
message and press Continue anyway.
Press Finish.
Step 3: Wait until you see a new entry appears in the Network Connections list called “Linux USB
Ethernet/RNDIS Gadget”. This is the reader.
If it says Acquiring IP address then you must wait until it says Connected.
The reader’s network connection will say:
Local Area Connection X
Connected
Linux USB Ethernet/RNDIS Gadget
Once it says Connected in the Network Connections window (Windows XP SP2) you can go to Step 4.
If it says Disabled or Broken, then click right and select Repair or Enable to try and  x the connection.
If this fails, disconnect the reader, reboot your PC and repeat from Step 1.
The reader can disconnect in situations where it has been repeatedly plugged and unplugged before Windows
has had a chance to properly and completely process the network connection. In this situation it is possible for
the reader to appear on the network for about a minute before it is disconnected by the Windows networking
system.
The solution is:
Unplug the reader.
Wait for the reader’s network connection to be removed from the Network Connections window.
1.
2.
3.
4.
1.
2.
3.
1.
2.
07-Jul-07 63-70-006-DOC 27
MARS-24E
User Manual