User's Manual

13-Nov-07 49-70-020-DOC 1949-70-020-DOC 19 19
MSTRP-5050 (MC 5/6)
User Manual
4.2.4 ConneCting multiple ReAdeRs to A loCAl netWoRk
Multiple readers can be connected to a local network using an Ethernet hub/switch. Plug the Ethernet
communication cable into the MSTRP-5050 Ethernet port and Ethernet hub/switch.
Always connect the Ethernet cable before power is applied to the reader.
4.2.5 leds
When power is applied to the MSTRP-5050 reader the LEDs should operate as follows:
the green Axis, Power and Channel LEDs will come on immediately
then they will go off in about 1 minute
the green Axis and Power LEDs will come on again in 1-3 seconds and remain permanently lit
indicating that the unit is in an operational mode; the green Channel LED will be off
1.
2.
3.
Axis LEDs
User controlled
output LEDs
Warning LED
Channel LEDs
Power LED