Operator's Manual

Unit 3: Installation
SATO GT4xxe Series Operator Manual PN 9001138C Page 3-14
LABEL CUTTER INSTALLATION
The label cutter, when installed, replaces the printer’s lower front housing cover. Its internal
sensor monitors media feed and activates the cut sequence based on user established values.
The cutter assembly is powered through relayed current from the printer’s power supply and
derives its primary intelligence from the main circuit board. The activated cut sequence severs
the printed media from the unprinted media allowing the operator to retrieve and apply at will.
Installation instructions are provided with the purchased product.
LABEL PEELER INSTALLATION
The label peeler, when installed, replaces the printer’s lower front housing cover. As the label is
printed and fed forward, the peel bar separates the printed label from its paper backing and
presents it for application. When the printed label is retrieved by the operator, the printer feeds
the unprinted media back into position for another print sequence. The cycle is again repeated.
Installation instructions are provided with the purchased product.