Instruction manual

Section 3: Operation and Configuration
CG2 Series Operator Manual Page 3-9
3.4 FACTORY TEST PRINT MODE
This mode produces test labels for diagnostic purposes.
Preparation:
Make sure the media or ribbon (if required) are properly loaded in the printer.
Notes:
• If you missed the chance to release the FEED/LINE button in step 3 above, just keep holding the FEED/
LINE button and wait for the next cycle.
• If you released the FEED/LINE button at the wrong ON LINE (POWER) indicator, just turn off the power
and restart the procedure.
• The printer will continuously print the Factory test labels until the FEED/LINE button is pressed. The print-
ing is paused and will resume printing if the FEED/LINE button is press again.
To terminate the Factory Test Print mode
First, ensure that you have pressed the FEED/LINE button to pause the test printing, then press POWER to
turn off the printer.
Solid red light
Printer start-up
While pressing
FEED/LINE button, press
POWER button
Release POWER button
and keep holding
FEED/LINE button.
Solid green light
Release FEED/LINE
button when ON LINE
(POWER) indicator
changes to solid red light.
Solid red light
Blinking green light
Press FEED/LINE button
to start test printing.
Factory Test Print
mode is activated and
then paused.
Solid green light
Factory Test Print start
after initial feed and
print continuously.
Press FEED/LINE button
to pause the test printing.
Press again to resume.
FactoryTest Print
paused.
Blinking green light
1
2
3
4
Printer status Procedures ON LINE (POWER) indicator
User Test Print Mode.
Factory Test Print Mode
(The printer will cyclically
advance to next mode as
long as the FEED/LINE
button is held down.)
Solid red light