Label Maker User Manual

Section 3: Configuration and Operation
Page 3-4 LM Basic 408e/412e Operator’s Manual
3.3 ACCESSING THE VARIOUS PRINTER MODES (CONT’D)
3.3.1 How to access special Modes and Menus after turning the power ON
Mode/Menu DSW Button(s) to press Comments
Normal NA Press LINE to toggle ONLINE/OFFLINE ONLINE/OFFLINE STATUS
Advanced NA Hold down the LINE button
when turning printer ON
Each time you pressing the LINE button,
you will rotate through Service Mode,
Counter Mode and Motion Mode
Service NA Press the LINE button in Advanced Mode Press LINE again to go to Counters Mode
Counter NA Press the LINE button in Service Mode Press LINE again to go to Motion Mode
Motion NA Press the LINE button in Counters Mode Press LINE again to return to Advanced
Mode
Test Print NA Press the FEED button when turning the
printer ON
Create test prints in this mode
Default
Settings
NA Press the LINE and FEED buttons when
turning the printer ON
Resets various user settings to factory
default values
Maintenance DSW2-4 If DIPSW2-4 is ON, printer goes into
Maintenance Mode. Set DSW2-4 off to
access Factory Mode
Press the LINE button to reach the ALL
CLEAR menu to restore all settings to fac-
tory default values
Flash
Download
Ready
DSW2-6 Set DSW2-6 ON when turning the printer
ON
Readies the printer to receive replacement
firmware code without boot codes
Boot
Downloader
DSW2-6 Set DSW2-6 ON and hold down the
FEED and LINE buttons when turning the
printer ON
Readies the printer to receive replacement
firmware code with boot codes
User
Download
DSW2-7 Set DSW2-7 ON and hold down the LINE
button when turning the printer ON
Readies the printer to receive user graphics
and fonts, etc
Protocol Code
Select
DSW2-7 Set DSW2-7 ON and hold down the
FEED and LINE buttons when turning the
printer ON
This method initializes the protocol code to
the default value
Hex Dump DSW2-4 Set DSW2-4 ON when turning the printer
ON
Generates a hex dump of memory
Hex Dump
(buffer dump)
NA Turn the printer ON. Send data to it,
press the LINE button to go offline, then
DSW2-4 On. Press Line again.
Generates successive hex dumps of incom-
ing data
History Control DSW2-4 Set DSW2-4 ON and hold down the LINE
button when turning the printer ON
Turns the Hysteresis (or History) Control
feature of the print head On/Off